Access Point" Mode - Kemper AirWatch Mode D'emploi

− Now enter the desired configuration in the stipulated fields.
− You can accept the default addresses set for the "Primary DNS" and "Secondary
DNS" fields. Use a separate DNS server, so you can enter its address in one or
both masks.

2.7 "Access Point" mode

If you should decide that you do not want to integrate the AirWatch in an existing
network, then a separate access point can be generated by selecting Access Point
mode.
Optionally, it is possible to allocate the AirWatch access point a designation other
than "AirWatchAP". For this, enter the desired designation in the "WiFi Name" mask
in the following diagram.
Part no.: 150 2608
All rights over changes without prior notice and errors reserved.
KEMPER AirWatch operating instructions - EN
- 51 -
Issue: 03/2017
Rev.: 00