After Using The Machine; Pushing/Towing The Machine; Machine Long Inactivity; First Period Of Use - Nilfisk BR 601 Manuel D'utilisation

USER MANUAL

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Remove the brushes/pad-holders according to the
procedure shown in the relevant paragraph.
2. Empty the tanks (15 and 16, Fig. I) according to the
procedure shown in the previous paragraph.
3. Perform the daily maintenance procedures (see the
Maintenance chapter).
4. Store the machine in a clean and dry place, with the
brushes/pad-holders and the squeegee lifted or
removed.

PUSHING/TOWING THE MACHINE

To push/tow the machine easily when the drive system
cannot be used, unlock the electromagnetic brake (27, Fig. C)
according to the following procedure:
– Screw down completely the internal screws (29, Fig. C)
(by turning them clockwise) with the supplied key.
When pushing/towing procedure is over, unscrew the screws
(29, Fig. C) for 3 turns approximately, to lock the
electromagnetic brake (27).
WARNING!
If the screws (29, Fig. C) are not unscrewed as
shown, the electromagnetic brake is
deactivated.
WARNING!
Do not start the machine when the
electromagnetic brake unlocking screws (29,
Fig. C) are screwed (electromagnetic brake
deactivated).

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in After using the
machine paragraph.
2. Disconnect the battery red connector (4, Fig. J) by
proceeding as follows:
– Lift the covers (1 and 13, Fig. I) and check that the
tanks (15 and 16) are empty, otherwise drain them
through the drain hose (10, Fig. C) and the tap (24).
– Close the covers (1 and 13, Fig. I).
– Carefully lift the tank assembly (1, Fig. J).
3. Drain the EDS-ECO Dosage Solution, according to the
procedure shown in Maintenance chapter (only for
machine equipped with EDS-ECO Dosage Solution
(optional)).

FIRST PERIOD OF USE

After the first 8 hours, check the machine fastening and
connecting parts for proper tightening. Check the visible parts
for integrity and leakage.
14

MAINTENANCE

The lifespan of the machine and its maximum operating
safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The
intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of
the maintenance.
WARNING!
The procedures must be carried out with the
machine off and the battery disconnected.
Moreover, before performing the maintenance,
carefully read all the instructions in Safety
chapter.
All scheduled or extraordinary maintenance procedures must
be performed by qualified personnel, or by an authorised
Service Center.
This Manual contains the Scheduled Maintenance Table and
describes only the easiest and most common maintenance
procedures.
NOTE
For other maintenance procedures shown in
the Scheduled Maintenance Table, refer to the
Service Manual that can be consulted at any
Service Center.
909 6160 000(2)2006-10 A