USER MANUAL
INTRODUCTION
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all
necessary information to use the machine properly, in a safe
and autonomous way. It contains information about technical
data, safety, operation, storage, maintenance, spare parts
and disposal.
Before carrying out any procedure on the machine, the
operators and qualified technicians must read this Manual
carefully. Contact Nilfisk-Advance in case of doubts
concerning the interpretation of the instructions and for any
further information.
TARGET
This Manual is intended for operators and technicians
qualified to perform the machine maintenance.
The operators must not carry out procedures reserved for
qualified technicians. Nilfisk-Advance will not be answerable
for damages coming from the non-observance of this
prohibition.
HOW TO KEEP THIS MANUAL
The User Manual must be kept near the machine, inside an
adequate case, away from liquids and other substances that
can cause damage to it.
CONFORMITY CERTIFICATE
Figure A shows the documentation certifying the
scrubber-dryer conformity with the law in force.
NOTE
Two copies of the original EC Declaration of
Conformity are provided together with the
machine documentation.
IDENTIFICATION DATA
The machine serial number and model are shown on the plate
(30, Fig. C) on the steering column.
The machine model year is written in the EC Declaration of
Conformity and it is also indicated by the first two figures of
the machine serial number.
This information is useful when requiring machine spare
parts. Use the following table to write down the machine
identification data.
MACHINE model ...........................................................
MACHINE serial number ...............................................
2
OTHER REFERENCE MANUALS
–
Electronic Battery Charger Manual (if equipped), to be
considered as integral part of this Manual
Moreover, the following Manuals are available:
–
Service Manual (that can be consulted at
Nilfisk-Advance Service Centers)
–
Spare Parts List (supplied with the machine)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures
must be carried out by qualified personnel or by
Nilfisk-Advance Service Centers. Only original spare parts
and accessories must be used.
Contact Nilfisk-Advance for service or to order spare parts
and accessories, specifying the machine model and serial
number.
CHANGES AND IMPROVEMENTS
Nilfisk-Advance constantly improves its products and
reserves the right to make changes and improvements at its
discretion without being obliged to apply such benefits to the
machines that were previously sold.
Any change and/or addition of accessories must be approved
and performed by Nilfisk-Advance.
SAFETY
The following symbols indicate potentially dangerous
situations. Always read this information carefully and take all
necessary precautions to safeguard people and property.
The operator's cooperation is essential in order to prevent
injury. No accident prevention program is effective without the
total cooperation of the person responsible for the machine
operation. Most of the accidents that may occur in a factory,
while working or moving around, are caused by failure to
comply with the simplest rules for exercising prudence. A
careful and prudent operator is the best guarantee against
accidents and is essential for successful completion of any
prevention program.
909 6160 000(2)2006-10 A