Publicité
—
3 Easy start
3.1 What this chapter contains
This chapter describes briefly the quick start and automatic commissioning procedure
for the controller.
3.2 Menu navigation
When the RVT is switched on power after the boot process (where the ABB logo is
displayed) the start screen is the first screen which will be displayed as shown in
13.
In the center of the screen the four icons (Measurements, Settings, Bank monitoring and
Communications) represent the four root-level menu.
At the bottom of the screen, the status bar shows the active capacitor steps, RVT Lock
status, warnings, the control source of the RVT(by local touch screen or
communications), switching on or off demand, operating mode: A (automatic mode), M
(manual mode) and S (setting mode). Detailed meaning of the status icons can be found
in following legends.
3.2.1
Legends for the touch screen icons
...
14 Easy start ç Manual Power Factor Controller RVT
Figure 13: RVT start screen
Active (closed) output ( inactive outputs are not highlighted )
bank settings unlocked
bank settings locked
Figure
Publicité
