Publicité
2.3 Lead connections
Please follow instructions below to connect wires to the terminals on the rear side of the
controller.
1. Push the lever of the connector backwards with a screwdriver.
2. Insert the wire (up to 2.5 mm
while keeping the pressure on the lever.
3. Release the screwdriver.
(c)
Step 4
Step 3
(d)
Step 5
(e)
Repeat steps 3 to 5 for
the bottom Mounting
Bracket.
Figure 6: Mounting a RVT
Figure 7: Lead connection
2
/single core) in the corresponding connection hole
Figure 8: Lead connection
Manual Power Factor Controller RVT ç Installation 11
Publicité
