Installing The Block Set - Dru Verwarming VENTEO E Mode D'emploi

USER MANUAL

10. Installing the block set

Position the block set as illustrated in fi gures 11 to 15.
It is important that the blocks are laid out in the correct
manner in relation to the fl ame image! Ensure that the ap-
pliance is working when laying out the blocks. In this way it
can be determined whether the blocks have a detrimental
effect upon the fl ame image!
1. Unpack the block set and check whether the blocks
have suffered any damage. If this is the case then please
contact your supplier.
2. Remove the glass pane (see chapter 7).
3. Lay block A on the left hand side of the base (fi gure 11).
4. Lay strip B on the right hand side of the base (fi gure 12).
5. Lay block C on the right hand side of the base, diagonally
over block A (fi gure 13). The must be laid slightly on top
of strip B (fi gure 14).
6. Lay strip D in the approximate area as illustrated in
fi gure 15.
7. If so desired the chips supplied can be laid on the base as
extra decoration.
8. Install the glass pane (see chapter 9). After installing
the glass pane, check that the fl ame image is still correctly
reproduced on the projection plate.
Figure 11
Figure12
16
Figure 13
Figure 14
Figure 15