Establishing The Network; Connection; Starting The Ceramill Motion; Operation - Amann Girrbach Ceramill Motion Mode D'emploi

▷ Insert the Ceramill-Match-Dongle in a free USB
port on the rear side of the PC.
Fig. 5 Ceramill-Match-Dongle
5.4 Establishing the Network Connec-
tion
To establish the network connection, the
milling machine and the PC must first be
connected via USB.
▷ Connect the Ethernet interface [2] of the milling
machine with the PC or with the network using
a network cable.
The maximum permitted length of the network
cable to the PC or to the network router is 100 m.
▷ Switch the milling machine on.
▷ Start the Ceramill Motion Software.
▷ After initializing the milling machine in the soft-
Settings
ware under >
connection type from USB to Ethernet and
adapt the IP address, if required (see descrip-
tion of the Ceramill Motion Software).
▷ Switch the milling machine off and then on
again.
▷ Initialize the milling machine in the software.
▷ After the software has detected the Ethernet
connection, remove the USB cable.
When operating via a network, up to eight
milling machines can be connected and
controlled via the Ceramill Match Soft-
ware.
Communication
, set the
I N S T A L L A T I O N
5.5 Starting the Ceramill Motion Oper-
ation
In addition to standard tools, sister tools can
optionally be inserted in the tool holder. When a
standard tool has reached its wear limit, the
Ceramill Motion automatically accesses the
respective sister tool.
▷ Insert the Ceramill Motion Roto standard tools
into the tool holder of the Ceramill Motion. Posi-
tion the tool shank facing toward the outside.
▪ Roto 2.5 is in the spindle.
▪ Set Roto 1.0 to position T2.
▷ Optional: Insert the sister tools into the tool
holder of the Ceramill Motion. Position the tool
shank facing toward the outside.
▪ Set Roto 2.5 to position T4.
▪ Set Roto 1.0 to position T5.
Fig. 6 Tool holder
E N
33