Amann Girrbach Ceramill Motion Mode D'emploi page 41

In order to clean the spindle:
▷ Briefly push service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked.
▷ Open the milling machine door.
▷ Push service button [B] on the milling machine.
The sealing air is activated and the service but-
ton lights up.
▷ Loosen the Allen screw at the bottom of the
spindle cap and remove the cap.
Fig. 12
▷
Fig. 13
▷ Remove any dust from the spindle using a dry,
soft cloth. Do not use cleaning agents!
C L E A N I N G A N D M A I N T E N A N C E
To remove the collet:
▷ Apply the black spindle wrench [5] over the col-
let.
Fig. 14
▷ Insert a milling tool into the open collet.
▷ Using the spindle wrench, unscrew the collet out
of the spindle.
Fig. 15
▷ Clean the collet holder using the felt cone [3].
The collet holder must be free of shavings/chips
and debris.
Fig. 16
5
3
41
E N