Application And Operation; Checking The Model Area - Amann Girrbach Ceramill Motion Mode D'emploi

6

Application and Operation

WARNING:
Danger from shavings/chips or tool fragments
being thrown from the machine!
▷ Make sure that the door of the milling machine
is always closed during the milling procedure!
NOTE:
Insufficient milling results and increased wear!
▷ Do not operate the milling machine without
extraction (e.g. Ceramill Airstream)!
The instructions for use (video tutorial) of the
Ceramill Match Software and the User Manual for
operation of the machine are on the Ceramill-
Match-CD or can be downloaded under
www.ceramill-m-center.com
A P P L I C A T I O N A N D O P E R A T I O N
.
6.1

Checking the Model Area

The model area, on which the work is to be
machined, must fit within the contour of the
enclosed template (also see match package). Oth-
erwise, the work cannot be machined in the blank.
The template takes into account the shrinkage of
the zirconium oxide in the final sintering.
Fig. 9 Template for ZI 71 zirconium oxide
▷ For work in wax or plastic, measure out the
model area.
E N
35