Set Up And Installation; Safety Information; Setting Up The Bath Lift - Invacare Aquatec Orca Manuel D'utilisation

Set up and installation

4 Set up and installation

4.1 Safety information

!
IMPORTANT
▸ Check the parts for transport damage before commissio-
ning and contact the dealer if required.
▸ Ensure during assembly that the parts are positioned cor-
rectly with respect to one another.

4.2 Setting up the bath lift

WARNING Risk of slipping!

The bath lift can slip if the suction cups do not have a good
hold.
▸ Clean the bathtub and the suction cups before setting up
the bath lift.
▸ Do not change the position of the bath lift in the bathtub
once it is set up.
WARNING Risk of injury and damage!

▸ Only set up the bath lift in bathtubs that comply with the
specifications of the following table.
≥ 800 mm
A Tub length,
bottom
B Tub width, bot- 280 - 600 mm
tom (inside)
≥ 430 mm
C Tub width, at
80 mm height
(inside)
≤ 420 mm (with height adapter,
H Tub height
(inside) max. + 60 mm)
E Tub width (out- 580 - 690 mm (with special side flaps)
side)
700 - 740 mm (with standard side flaps)
750 - 1000 mm (with special side flaps)
!
IMPORTANT
▸ Ensure that the suction cups are mounted.
▸ Ensure that the battery in the hand control is charged.
▸ Ensure that the spindle foot is fully inserted.
▸ When lifting, please remember: the seat weighs 7.5 kg, the
backrest 4.6 kg (without the hand control).
▸ If the bathtub has a handrail, use the side flap diverters.
▸ Fold the side flaps outwards before raising the backrest.
Bathlift Orca / Orca F / Orca XL
7