Identification Label; Assembly And Installation; Safety Information; Assembling The Shower And Toilet Commode - Invacare Aquatec Ocean Mode D'emploi

Shower and Toilet Commode Ocean / Ocean XL
Ⓐ Self-propelling wheels (2 x)
B Parking brakes (2 x)
Ⓒ Hubs (2 x)
Please note the change in dimensions when the self-propelling wheels
are fitted. The details are provided in the technical data.

3.2 Identification label

The identification label also contains important information:
G
F
E
D
C
A Conformity mark
B Product timeframe
C Serial device number
D Load capacity
E Note (use only on flat surfaces)
F Note (observe accompanying documents)
G Device designation
The identification label is positioned on the inside of theright-
i
hand side part.
6
4

Assembly and installation

4.1 Safety information

!
IMPORTANT
▸ Check the parts for transport damage before commissio-
ning and contact the dealer if required.
▸ Ensure during assembly that the parts are positioned cor-
rectly with respect to one another.

4.2 Assembling the shower and toilet commode

This section describes the assembly. Disassembly takes place in the
reverse order.
Fitting the side parts
B
1. Remove the enclosed clips F from the bag.
2. Place the seat frame on its side.
!
IMPORTANT
▸ Push the side part evenly onto the frame and do not twist.
▸ Secure the side part at the same height, front and rear.
Assembly and installation