Adjusting The Seat Height - Invacare Aquatec Ocean Mode D'emploi

Assembly and installation
3. Push the side part with the guides for the footrests
A
on the seat frame B.
4. Bring the clip mounts on the front and back of the side part in
E
line with a hole in the seat frame C.
5. Insert the clips from the outside into the side part, until both
F
ends enclose the seat frame tube B.
G
!
IMPORTANT
▸ Ensure that the left and the right side parts are set to the
same height.
6. Turn the seat frame and repeat the procedure on the second side
part.
7. Set the seat frame with the fitted side parts on its wheels.

Adjusting the seat height

!
IMPORTANT
The seat height is to be adapted to the user. It is generally
correctly adjusted if the user can sit on the shower and toilet
commode with both feet resting on the floor.
▸ Change the height to the same level on both sides.
▸ Do not adjust the seat height while there is someone sitting
on the shower and toilet commode.
1. Raise the shower and toilet commode slightly on one side by the
seat frame B.
2. Remove both clips on this side.
F
3. Pull the seat frame out of the side part
part to adjust the seat height.
4. Push both clips back in completely.
5. Raise the other side and set to the same height as described.
forwards
D
or push it into the side
A
Shower and Toilett Commode Ocean / Ocean XL
Fitting the base stabilization tube (Ocean XL only)
1. Fit the base stabilization tube
and nuts supplied between the side parts C.
B
using the screws
A
7