9.1 Identifying And Repairing Faults - Invacare Aquatec Orca Manuel D'utilisation

Bathlift Orca / Orca F / Orca XL
9 Troubleshooting

9.1 Identifying and repairing faults

The following table provides information on malfunctions and
i
their possible causes.
If you cannot correct the malfunction using the remedies
named, please contact your dealer directly.
Fault
No motor noise audible/lift does not move.
The lift can be raised but not lowered.
The lift stops while being raised.
The bath lift is not adhering securely to the
bathtub.
Battery is not charging and the red indicator
light flashes during charging
14
Possible cause
Jack socket of the hand control is not
locked correctly.
Battery is flat.
Contacts are dirty.
Cable is crushed/damaged.
Low-voltage protection is activated
Excessive load.
Suction cups are old or damaged.
Faulty electronics.
Faulty battery.
Faulty charger.
Battery is too hot
Remedy
Lock the jack socket,
▸ see Section 4.2, Step 5.
Recharge the battery completely,
▸ see Section 4.4.
Clean the contacts,
▸ contact your dealer, if necessary.
Replace the hand control,
▸ contact your dealer, if necessary.
Recharge the battery completely,
▸ see Section 4.4.
Observe maximum load,
▸ see Section 10.1.
Replace the suction cups,
▸ contact your dealer, if necessary.
▸ Have your authorized dealer check the hand control.
▸ Replace the hand control.
▸ Have your authorized dealer check the charger.
▸ Do not charge the hand control near heat sources, e.g.
heating elements, in direct sunlight. Charging continues
automatically once the temperature drops to within
permissible limits.
Troubleshooting