Installing Landing Gear; Installing Horizontal Tail - Horizon Hobby ParkZone T-28 Trojan Manuel D'utilisation

Installing the Landing Gear
Installation
1. Turn the model so the bottom of the wing faces up.
2. Install the main landing gear by inserting the main gear
struts (A) into the corresponding gear plate hole located on
each wing.
3. Carefully turn each strut in the gear plate until the horizontal
section (B) of the strut gently snaps into place.
4. Loosen the nose gear screw (C) in the nose gear arm before
installing the nose gear strut (D). The screw may be fully
installed at the factory, so loosen the screw enough to ensure
the screw does not block the strut. A hole in the cowling
allows a screwdriver to be used to turn the screw on the nose
gear arm.
If more maneuvering space is needed, remove the propeller
and cowling from the model before installing the nose gear.
(As shown in the "Service of Power Components" section
of this manual.)
5. Install the nose gear strut so the fl at surface of the strut faces
forward. The coil in the nose gear strut should face the rear
of the airplane. Fully insert the nose gear strut into the nose
gear arm. When inserted, the top of the strut will touch the
upper portion of the fi rewall.
6. Fully tighten the nose gear screw against the fl at surface of
the nose gear strut.
7. When needed, disassemble in reverse order.
Always ensure the steering linkage clevis on the rudder servo
arm is correctly adjusted so the model steers straight when the
rudder control is at neutral.
Installing the Horizontal Tail
1. Place the model on its landing gear.
2. Turn the horizontal tail so the control horn faces down.
3. Slide the horizontal tail in the horizontal tail mount until it is centered
perpendicular to the vertical tail.
4. Apply four pieces of tape on the fuselage mounts and the top and bottom of
the horizontal tail.
5. Attach the clevis to the elevator control horn (see instructions for
clevis connection).
6. When needed, disassemble in reverse order.
D
C
EN
A
B
7