Nose Gear Service - Horizon Hobby ParkZone T-28 Trojan Manuel D'utilisation

Nose Gear Service

Hard landings may damage the nose gear. Replace damaged parts as needed.
CAUTION: DO NOT handle the propeller while the fl ight battery is
connected to the ESC. Personal injury could result.
1. Remove the canopy from the model.
2. Disconnect the fl ight battery from the model.
3. Disconnect the steering clevis from the rudder servo arm.
4. Remove the propeller and cowling from the model. (As shown in the
"Service of Power Components" section of this manual.)
5. Loosen the nose gear screw and remove the strut.
6. Remove the two screws (A) and steering arm retainer (B) (PKZ4408,
retainer with steering arm) from the fi rewall.
7. Pull the steering linkage (C) forward and remove the Z-bend end (D) of
the linkage from the steering arm (E) (PKZ4408, including steering arm
retainer).
8. Reinstall the steering arm on the Z-bend end of the linkage.
9. Install the steering arm in the fi rewall using the steering arm retainer
and two screws.
10. Connect the linkage clevis to the rudder servo arm.
11. Install the strut using the screws.
12. Reinstall the cowling, propeller and canopy on the model.
NOTICE: Always make sure the steering linkage clevis is adjusted correctly to
ensure the model steers straight when the rudder control is at neutral.
MAINTENANCE
B
A
2.5X12mm (2)
C
D
E
11
EN