Dual Rates; Service Of Power Components - Horizon Hobby ParkZone T-28 Trojan Manuel D'utilisation

EN

Dual Rates

We recommend using a DSM2/DSMX aircraft transmitter capable of dual rates.
Adjust according to individual preferences after initial fl ight.

Service of Power Components

Disassembly
CAUTION: DO NOT handle the motor or ESC while the fl ight battery is
connected to the ESC. Personal injury could result.
1. Use a tool to remove the spinner nut (A) from the collet (B).
2. Remove the propeller (C), backplate (D) and collet from the motor shaft.
3. Remove three screws (E) from the cowling (F).
4. Carefully remove the cowling from the fuselage. Paint may keep the
cowling attached to the fuselage.
5. Remove four screws (G) from the motor mount (H) and fuselage.
6. Disconnect the motor wires from the ESC wires.
7. Remove four screws (I) and motor (J) from the motor mount. Keep
the rubber washers attached to the motor mount when removing the
screws and motor from the motor mount.
A C D B
CAUTION: Always disconnect the fl ight battery from the model before removing the propeller.
10
MAINTENANCE
Assembly
1. Assemble in reverse order. Correctly align the colors of the motor wires
NOTICE: Make sure the propeller side with the numbers for diameter and
pitch (9.5 x 7.5) faces out from the backplate. A tool is required to tighten
the spinner nut on the collet.
F J G
E
2X5mm (3)
High Rate
Aileron 13mm up/down
Elevator 16mm up/down
Rudder 22mm left/right
with the wire colors of the ESC.
H I
3X10mm (4)
G
1.5X10mm (4)
Low Rate
9.5mm up/down
13mm up/down
16mm left/right
Not all wiring shown.