Technical Specifications - Beurer IH 50 Mode D'emploi

Problem/ Possible Cause/Remedy
Question
Output is too 1. The batteries are flat. Replace the
low. batteries or connect the power
supply unit and try again.
2. There are air bubbles inside the
medicine container which are pre-
venting the medicine from coming
into continuous contact with the
mesh. Please check and remove
any air bubbles.
3. Particles on the mesh are imped-
ing output. To remove the par-
ticles, fill the nebuliser with 2 to
3 drops of vinegar and 3 to 6 ml
of water, then nebulise this solu-
tion completely. Do not inhale this
spray and ensure that you clean
and disinfect the medicine con-
tainer afterwards (see page 17).
If the output does not improve, re-
place the mesh.
4. The mesh is worn out.
Which medi- Only the doctor can advise you
cines are suit- which medicine to use to treat your
able for inhala- condition. Consult your doctor.
tion? With the IH 50, you can atomise
medicines with a viscosity lower
than 3.
Some inhala- This is normal and occurs for techni-
tion solution cal reasons. Stop inhaling as soon
remains in the as you can hear a marked differ-
nebuliser. ence in the sound made by the at-
omiser, or when the device switches
off automatically due to insufficient
inhalant.
What special 1. In babies, the mask should cover
steps should the mouth and nose to guarantee
be taken for effective inhalation.
babies and 2. In children, the mask should also
children? cover the mouth and nose. Nebu-
lisation next to a sleeping person
is not suitable because insufficient
medicine reaches the lungs.
Note: Children should only use the
device with help and under supervi-
sion of an adult. Never leave a child
alone with the nebuliser.
Inhalation with This is for technical reasons. Less
the mask takes medicine is inhaled per breath
longer. through the mask holes than us-
ing the mouthpiece. The aerosol is
mixed with ambient air through the
holes in the mask.
Does each user This is absolutely necessary for hy-
need their own giene reasons.
accessories?

9. Technical specifications

Dimensions
(LxWxH) 72 x 59 x 143 mm
Weight 238 g incl. batteries
Battery operation 4 x 1.5 V type AA, Mignon (LR6)
Volume max. 8 ml
Medicine flow approx. 0.25 ml/min.
Oscillation
frequency 100 kHz
Housing material ABS / TPE
Mains
connection 100 – 240 V ~, 50 – 60 Hz; 0,15 A
Operating Temperature: +5 °C – +40 °C
conditions Relative humidity: <80 % non-con-
densing
Storage and Temperature: -10 °C – +45 °C
transport Relative humidity: <80 % non-con-
conditions densing
Subject to technical modifications.
Wearing parts are not covered by the guarantee.
Spare parts
Designation
Mouthpiece
Adult mask
Child mask
Mesh atomiser with
medicine container
Power pack
Connecting piece
Yearpack
(Mouthpiece, Adult mask,
Child mask, Mesh atomiser,
Connecting piece)
All measurements were obtained with a sodium chlo-
ride solution using a laser diffraction method.
19
Material REF
PP 162.658
PVC 162.712
PVC 162.659
PC 162.711
PC+ABS 071.18
PC 162.665
PP, 603.05
PVC, EVA,
PET