Troubleshooting; Technical Specifications; Replacement Parts And Wearing Parts; Warranty And Service - Beurer SI 40 Mode D'emploi

8. Troubleshooting

Problem/ Possible cause/remedy
question
The ON/OFF Check the power connection to
switch has the socket and check whether the
been swit- mains plug has been plugged in
ched on, but correctly.
the device is
not working.
The device is 1. Check that there is water in the
switched on container of the water heater
but produces tank.
no or hardly
2. Check that there is liquid in the
any steam.
aromatherapy container.
3. Make sure that the suction tube
and other components have
been attached properly.
4. Check the nozzle for blockages.
Clean the nozzle if necessa-
ry (see "Cleaning the nozzle"
section in the "Cleaning and
disinfection" chapter)
Does every- Yes, this is absolutely essential for
one need hygiene reasons.
a separate
mask?

9. Technical specifications

Model
SI 40
Dimensions
(W x H x D) 265 x 260 x 96 mm
Weight
620 g
Filling volume
of internal water
heater Max. 25 ml
Filling volume of
aroma tank Max. 60 ml
Mains connection 220 – 240 V~; 50 – 60 Hz
Steam
Approx. 43°C
temperature
Water boiling time Approx. 2 minutes
Maximum
Approx. 10 minutes
operation time
Operating Temperature: +10°C to +40°C
conditions Relative humidity: 10% to 95%
Ambient pressure: 700 hPa to
1060 hPa
Storage and Temperature: 0°C to +60°C
transportation Relative humidity: 10% to 95%
conditions Ambient pressure: 500 hPa
to 1060 hPa
Subject to technical changes.
Please contact the specified service address to ob-
tain further information, such as the CE Declaration
of Conformity.
10. Replacement parts and
wearing parts
Designation
Mask

11. Warranty and service

In case of a claim under the warranty please contact
your local dealer or the local representation which is
mentioned in the list "service international".
In case of returning the unit please add a copy of
your receipt and a short report of the defect.
The following warranty terms shall apply:
1. The warranty period for BEURER products is
either 3 years or – if longer – the country specific
warranty period from date of Purchase.
In case of a warranty claim, the date of purchase
has to be proven by means of the sales receipt or
invoice.
2. Repairs (complete unit or parts of the unit) do not
extend the warranty period.
3. The warranty shall not be valid for damages
because of
a. improper treatment, e.g. nonobservance of the
user instructions.
b. repairs or tampering by the customer or
unauthorised third parties.
16
Material REF
PVC 601.34