Disposal; Troubleshooting - Beurer SR IH 1 Mode D'emploi

• Put the parts together again when they are completely
dry and place them in a dry, sealed container.
Note
• Please ensure that the parts are completely dried after
cleaning, otherwise the risk of bacterial growth is in-
creased.
• Use cold disinfection solution in accordance with the
manufacturer's instructions.
Drying
• Place the individual parts on a clean, dry and absorbent
surface and leave them to dry completely (at least 4
hours).
Durability of materials
• As with any plastic parts, atomisers and their accesso-
ries are affected by a certain amount of wear and tear
when used and hygienically prepared on a frequent ba-
sis. Over time, this can lead to a change in the aerosol,
which can have a negative effect on the efficiency of the
treatment. We therefore recommend that you replace
the atomiser and other accessories after a year.
• The following point should be observed when selecting
the cleaning product or disinfectant: only use a mild
cleaning product or disinfectant in the concentration
and volume prescribed by the manufacturer.
Storage
• Do not store in damp conditions (such as in a bathroom)
and do not transport with any damp items.
• When storing and transporting, protect from prolonged
direct sunlight.
• The accessories can be stowed securely in the ac-
cessory compartment. Store the device in a dry place,
ideally in the original packaging.

9. Disposal

For environmental reasons, do not dispose of the
device in the household waste.
Please dispose of the device in accordance with
EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the
local authorities responsible for waste disposal.
The empty, completely flat rechargeable batteries must
be disposed of through specially designated collection
boxes, recycling points or electronics retailers. You are
legally required to dispose of the rechargeable batteries.
The codes below are printed on rechargeable batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury

10. Troubleshooting

Problem/ Possible cause/remedy
question
The atomiser 1. Too much or too little medication
produces no
or too little
aerosol.
2. Check nozzle for blockages.
IMPORTANT: Carefully pierce the
fine holes from the underside of the
nozzle only.
3. Atomiser not held vertically.
4. Unsuitable medication fluid added
The medication fluid should be pre-
scribed by the doctor.
The output is Kinked hose, clogged filter, too much
too low. inhalation solution.
What med- Please consult your doctor in rela-
ications are tion to this matter.
suitable for As a rule, all medication that is
inhaling? suitable and approved for device
inhalation can be inhaled.
There is inha- This is normal and is due to technical
lation solution reasons. Stop inhalation once the
residue in the atomiser starts to make a notably
atomiser. different sound.
22
in the atomiser.
Minimum: 2 ml,
Maximum: 6 ml.
Clean nozzle if necessary (e.g. by
rinsing out). Then start using the
atomiser again.
for nebulisation (e.g. too viscous).