Cleaning And Care Of The Unit; Storage; Disposal; What If There Are Problems - Beurer TL 70 Mode D'emploi

6 Important instructions
When using the lamp, maintain the recommended distance of 10 - 40 cm between your face and the
lamp. The duration of the application depends on the distance:
Distance
Up to 10 cm
Up to 25 cm
Up to 40 cm
Basically, the closer you are to the source of light, the less time you should use it.
7 Enjoying light over longer periods
Repeat your use of the lamp in the dark seasons for at least 7 successive days, or even longer, depen-
ding on your individual needs. If possible, conduct the treatment in the morning hours.
8 Switching off the lamp
 Press the On/Off button. The LEDs switch off. Unplug the mains part from the mains socket.
CAUTION!
The light remains hot after use.. Let the lamp cool off first long enough before you put it away and/or pack
it up!

7. Cleaning and care of the unit

The unit should be cleaned occasionally.
Important
• Ensure that no water penetrates inside the unit!
Before you clean the unit, always switch it off, unplug it and let it cool off.
• Do not wash the unit in a washing machine!
Use a slightly damp cloth to clean the device.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the
unit. The unit must be operated only when it is completely dry.
Do not use abrasive detergents and never immerse the unit in water.

8. Storage

If you are not going to use the device for an extended period of time, disconnect it and store it in a dry place, out
of the reach of children.
Follow the storage instructions provided in the "Technical data" chapter.

9. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful
life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accord-
ance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.

10. What if there are problems?

Problem Possible cause
Device does not On/off button switched off
light up
No electricity
No electricity
LEDs have reached the end of their service life.
LEDs faulty.
Duration
½ hour/day
1 hour/day
2 hours/day
Solution
Switch on the on/off button.
Connect the mains part properly.
The mains part is faulty. Contact cus-
tomer services or your retailer.
If you need to have the unit repaired,
contact customer service or an author-
ised dealer.
13