Cleaning And Care Of The Unit; Replacing The Lamp Tubes/Starter; Storage; Disposal - Beurer TL 90 Mode D'emploi

6 Switching off the lamp
 Press the On/Off button. The tubes turn off. Pull the mains plug from the socket.
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it away and/or
pack it up!

7. Cleaning and care of the unit

The unit should be cleaned occasionally.
Important
• Ensure that no water penetrates inside the unit!
Before you clean the unit, always switch it off, unplug it and let it cool off.
• Do not wash the unit in a washing machine!
Clean using a damp cloth, to which you can apply a little detergent if necessary.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the
unit. The unit must be operated only when it is completely dry.
Do not use abrasive detergents and never immerse the unit in water.

8. Replacing the lamp tubes/starter

The service life of the fluorescent tubes is on average 10,000 hours. If one tube needs replacing, both fluorescent
tubes must be replaced with new tubes of the same type. For this purpose, contact a retailer, an authorised ser-
vice centre or appropriately qualified personnel or contact the customer service.
The following tubes are approved as replacement:
• YDW 36-H.RR 2G11
• T he manufacturer's tubes are available with the order number 162.942 from customer support
Warning
• F or environmental reasons, do not dispose of the fluorescent tubes with the household waste. Dispose of
the unit at a suitable local collection or recycling point. Please contact the local authorities responsible for
waste disposal.
• U nplug the device, to avoid the risk of electrocution.
• T ake care when handling fluorescent tubes to avoid the risk of cut injuries.

9. Storage

If you are not going to use the device for an extended period of time, disconnect it and store it in a dry place, out
of the reach of children.
Follow the storage instructions provided in the "Technical data" chapter.

10. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful
life. Dispose of the device at a suitable local collection or recycling point. Dispose of the device in accord-
ance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.

11. What if there are problems?

Problem Possible cause
Device does not On/off button switched off
light up
No electricity
No electricity
Fluorescent tube has reached the end of its
service life. Fluorescent tube is defective.
Solution
Switch on the on/off button.
Connect the mains plug correctly.
The mains cable is defective. Contact
customer services or your retailer.
If you need to have the unit repaired,
contact customer service or an author-
ised dealer.
13