Unit Description; Initial Use; Mains Connection; Operation - Beurer TL 90 Mode D'emploi

General notes
Important
• If you are taking medication such as pain relievers, antihypertensives or antidepressants, consult your
doctor before using the daylight therapy lamp.
• People with retinal diseases as well as diabetics need to be examined by an ophthalmologist before be-
ginning to use the daylight therapy lamp.
• Please do not use if you have an eye disease such as cataracts, glaucoma, diseases of the optic nerve in
general and inflammation of the vitreous humour.
• Always consult a doctor before using the daylight therapy lamp if you have a strong sensitivity to light or
you are prone to migraine attacks.
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• The lamp tubes are excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.

4. Unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. Stand
4. On/Off button
5. LED display

5. Initial use

Take the device out of the plastic wrapping. Check the device
for damage or faults. If you notice any damage or faults on
the device, do not use it and contact customer services or
your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 15 cm and
50 cm between the user and the device. The lamp is most effective at this distance.

Mains connection

Connect the unit only to the mains voltage listed on the type plate. Push the plug completely into the mains
socket.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.

6. Operation

1 Switching on the lamp
 Press the On/Off button. The tubes turn on. Set the angle of the fluorescent screen in accordance
with your individual requirements.
ATTENTION!
The brightness of the tubes may be visibly different when switched on. The tubes develop
their full luminosity after a couple of minutes.
5.
11
1.
2.
3.
4.