Unit Description; Initial Use; Operation - Beurer TL 41 Mode D'emploi

• Do not use the device if it is damaged. If the device is not working, try to solve the problem using the infor-
mation in chapter "What if there are problems?". If you are unable to solve the problem, contact Customer
Services or an authorised retailer.

4. Unit description

Overview
1. Fluorescent screen
2. Rear of the device housing
3. Support feet
4. On/off button
5. Mains cable with plug
6. Stand
7. Hole for wall-mounting fixture

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 20 cm and
45 cm between the user and the device. The lamp is most effective at this distance.
Mounting the device on the wall
Alternatively, you can also mount the device on the wall. This requires a solid wall with a stable suspension de-
vice (for concrete walls e.g. a 25 mm long M4 stainless steel self-tapping screw and wall plug). Only mount the
device on the suspension device at the hole (located centrally on the rear of the device). Self-tapping screw and
wall plug are not included in delivery.
:
Important
If the area around the hole in the rear of the device is cracked or damaged, do not mount the device on the
wall! For help, please contact customer services or your retailer.
Note:
• Ensure that there is a mains socket close to the set-up area.
• Ensure that the mains part plug is completely inserted in the mains socket.
• Arrange the mains cable so that no-one will trip over it.

6. Operation

1 Switching on the lamp
 Press the On/Off button.
1
2
3
4
13
5
6
7