Setting The Temperature; Switching Off; Cleaning And Care - Beurer UB30 Mode D'emploi

4.4 Setting the temperature

0 = Off
1 = Minimum heat
2 = Medium heat
3 = Maximum heat
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overhe-
ating of the user.
NOTE:
• The quickest way to heat up the heated underblanket is to select the highest temperature setting
of the controller, first.
• We strongly recommend switching on the heated underblanket approx. 30 minutes before going
to bed and covering it with the quilt to prevent the warmth from escaping.

4.5 Switching off

To controller off the heated underblanket, set the slider for ON/OFF and temperature settings to the OFF (0)
position. The temperature settings are then no longer illuminated.
NOTE:
If the heated underblanket is not used for several days, set the slider for ON/OFF and temperature
settings to the OFF (0) position and remove the mains plug from the socket.

5. Cleaning and care

WARNING
Always remove the supply plug from the mains outlet and remove the controller
from the heated underblanket by disconnecting it at the connector.
Otherwise there is a risk of an electric shock.
CAUTION
The controller must never come into contact with water or other liquids, as this may cause damage.
To clean the controller use a dry, lint-free cloth.
To remove stains from the heated underblanket use a damp cloth and, if necessary, a mild cleaning agent.
Do not use cleaning agents containing solvent or scouring agents.
If extremely dirty, these heated underblanket can be washed by hand at 30°C (do not use the hand wash cycle
on the washing machine). Use a mild liquid detergent for the hand wash (dosage according to manufacturer's
instructions).
CAUTION
• Note that the heated underblanket must not be dry-cleaned, wrung out, machine dried or ironed.
• Do not attach the heated underblanket to washing lines with washing pegs or the like. Otherwise the
heated underblanket may be damaged.
• Only reconnect the controller to the heated underblanket after the connector and the heated under-
blanket are completely dry. Otherwise the heated underblanket may be damaged.
13