Operation - Beurer TL 70 Mode D'emploi

Mains connection
• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
part described here.
• Insert the mains part into the connection provided for this purpose on the rear of the daylight therapy
lamp. The mains part must only be connected to the mains voltage that is specified on the type plate.
• After using the daylight therapy lamp, unplug the mains part from the mains socket first and then discon-
nect it from the daylight therapy lamp.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.

6. Operation

1
Insert the mains part into the connector.
2 Switch on the light
 Press the ON/OFF button.
3 LED display/timer
The daylight therapy lamp TL 70 indicates your current treatment time with the aid of 5 LEDs.
The treatment time can be set at the following 5 levels.
The timer function is not activated when the light is switched on for the first time. The light now shines
until it is switched off again or a treatment time is set (timer = 0 min).
In order to use the timer, set the desired level from 1 to 5 using the „+/-" buttons. On level 1, a treatment
time of 15 minutes is set. The other levels are as follows:
Treatment time
15 Minutes
30 Minutes
45 Minutes
90 Minutes
120 Minutes
The light switches off automatically after this treatment time. If you wish to deactivate the timer function,
you can press the „-" button until the LEDs go out.
4 Brightness adjustment
The daylight therapy lamp TL 70 has 10 brightness levels. The desired brightness level can be set using
the „+/-"
buttons on the side – this level should be set so that it is pleasant for the eye during the treatment.
When the device is switched off, the last level that was set is saved. When the device is next switched
on, it restarts with the saved brightness level.
5 Enjoying the light
Sit as close as possible to the lamp, between 10 cm and 40 cm. You can go about your normal activities
while using it. You can read, write, make telephone calls, etc.
• Every so often, briefly look directly into the light, since the effect results from the eyes/ retina receiving
the light.
• Use the daylight therapy lamp as often as you want. However, the treatment is at its most effective if
you carry out the light therapy according to the prescribed time period of at least 7 successive days.
• The most effective time of day for the treatment is between 6am and 8pm
and we recommend that it is used for 2 hours per day.
• Do not look directly into the light the whole time you are using it, however, since that could lead to
overstimulation of the retina.
• Start with shorter periods of illumination, which you increase over the course of a week.
Note:
Eye aches and headaches may arise after the first times using the lamp. These will go
away in later sessions, as the nervous system will become accustomed to the new stimulation.
Number of lit LEDs
1
2
3
4
5
12