Operation - Beurer EM 27 Mode D'emploi

3. Insert the plug for the connec-
tion cable into the connector
socket [5] on the control unit.
Replacing the battery
Please replace the batteries
when the battery status sym-
bol appears in the display [7].
• Open the battery compartment [4]
by pushing the cover in the area
marked with an arrow and sliding
downwards.
• 3 x 1.5 V batteries, type AAA (LR 03 Micro) should be
inserted for operation. Ensure the polarity is correct.
Observe the graphic in the battery compartment.
• Do not use rechargeable batteries.

6. Operation

General notes on use
Do not switch on the device until the cuff is correctly
positioned. See chapter 5.
The ankle TENS is intended for individual treatment of pain
in the ankle.
Switching on
Hold down the On/Off button [1] until a short signal sounds
and the LCD display [6] switches on. When the device is
switched on for the first time, program A is automatically
activated.
Selecting a program
Press the program button P [3] to switch between the pro-
grams.
The following programs are available:
Program Frequency
A 4 Hz – 110 Hz (3 phases)
B 4 Hz
C 2 Hz (burst)
D 110 Hz
Note:
With program A, you will feel the effect become
stronger when the program changes from phase 1
to phase 2 (after approx. 10 minutes). This is normal
and intentional. If the intensity seems too high, you
can lower it by simply pressing the intensity button
▼ [2].
26
Time
30 min.
25 min.
25 min.
25 min.