Initial Use - Beurer EM 27 Mode D'emploi

7 Battery status, appears when batteries are dead
8 Intensity, level 0 – 20
9 Pause symbol, flashes when activated
10 TIMER: Remaining time in the active
program in minutes
11 Button lock active
12 Active program

5. Initial use

Inserting the batteries
Open the battery compartment [4]
by pushing the cover in the area
marked with an arrow and sliding
downwards.
Insert the 3 alkaline AAA 1.5 V bat-
teries. When inserting the batteries,
ensure that the correct polarity is
observed.
Then close the battery compartment
lid until you hear and feel it click into
place.
Connecting the connection
cable and positioning the
ankle cuff
1. Connect the connection cable
with the metallic connection clips
on the ankle cuff.
Note
Before positioning the ankle cuff, first clean the body
parts to be treated.
Before positioning the ankle cuff, first moisten
the water contact electrodes and the ankle
with water.
Place the cuff onto the ankle. At this point, ensure that
the surfaces of the water contact electrodes surround
the ankle. In doing so, the round opening of the cuff
must lie on the heel.
2. Fix the cuff in the desired
position using the hook-and-
loop fasteners. Ensure that the
cuff is not too tight but that the
water contact electrodes still
have sufficient contact with the
skin.
25