Troubleshooting; Fcc Compliance Statement; Warranty - Beurer GS 203 Mode D'emploi

Pèse-personne design
Masquer les pouces Voir aussi pour GS 203:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. Troubleshooting

The following error messages can appear.
Error display
Possible causes of errors
The maximum capacity of 330 lb (150 kg
Err
/ 24 st) has been exceeded.
Low Power.
Lo
No display.
Scale shows unrealistic result.

9. FCC Compliance Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

10. Warranty

Limited Lifetime Warranty For Original Purchaser
Your Beurer Designer Glass Scale, model GS 203, is warranted to be free from defects in materials and
workmanship for the life of the product under normal conditions of intended use and service. This warranty
extends only to the original retail purchaser and does not extend to retailers or subsequent owners.
We will, at our option, repair or replace the Beurer Designer Glass Scale, model GS 203, without additional
charge, for any part or parts covered by these written warranties. No refunds will be given. Repair or replace-
ment is our only responsibility and your only remedy under this written warranty. If replacement parts for
defective materials are not available, Beurer reserves the right to make product substitutions in lieu of repair
or replacement.
For warranty service contact our customer service department at 1-800-536-0366 or at info@beurer.com to
provide a description of the problem. If the problem is deemed to be within the scope of the limited lifetime
warranty, you will be asked to mail the product at your costs in its original package with proof of purchase,
your name, address and phone number. If the problem is not deemed to be within the scope of the limited
lifetime warranty, we will provide a quotation for repair respectively replacement and return shipping fee.
Correction of errors
Weigh only the maximum permissible
weight.
Change the batteries.
Batteries are empty, battery was inserted
incorrectly or the scale is broken.
Wait until scale switches off automatically.
Repeat measurement.
Place the scale on hard level flooring (no
carpet).
Don't move during weighing.
6

Publicité

Table des Matières
loading

Table des Matières