Useful Information On The Device; Accessories - Beurer IH 50 Mode D'emploi

Notes on handling batteries
• Keep batteries out of the reach of children. Children
can put batteries in their mouths and swallow them.
This can cause severe harm to their health. In this
case, consult a physician immediately!
• Normal batteries must not be recharged, heated or
thrown into open flame (risk of explosion).
• Leaking batteries may damage the device. If you do
not intend to use the device for prolonged periods,
remove the batteries from the battery compartment.
Warning
Leaking or damaged batteries can cause burns if they
touch the skin. When removing such batteries, wear
suitable protective gloves.
Repairs
Note
• Never open or attempt to repair the unit yourself, as
otherwise proper function is no longer guaranteed. Fail-
ure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer
service or an authorised dealer.

4. Useful information on the device

Accessories

The safe functioning of the device can only be guar-
anteed if the accessories recommended by the manu-
facturer are used.
Important
Protecting against leaks
When filling the medicine container with medicine,
ensure that you do not exceed the maximum mark
(8 ml). The recommended filling amount is between
2 and 8 ml.
During use, you can tilt the device up to a maximum
angle of 45 ° in any direction, without impairing its neb-
ulising function or the success of the treatment. How-
ever, spraying only takes place if the substance to be
sprayed is in contact with the mesh. If it is not, spray-
ing stops automatically.
However, please try to hold the device as upright as
possible.
Automatic switch-off
The device has an automatic switch-off function. To
prevent damage to the mesh, the device switches off
automatically when the medicine/liquid has been al-
most entirely used up.
Do not use the device if the medicine container or wa-
ter tank is empty.
The device switches off automatically if the substance
to be sprayed is no longer in contact with the mesh.
14