Setup Menu (Determining Basic Settings) - Hydac FluidControl Unit FCU 8000-1 Série Manuel D'utilisation Et D'entretien

Operating and Maintenance Instruction FCU 8000-1 series

7.5 SETUP Menu (determining basic settings)

Description
Under this menu the user can carry out or alter different basic settings himself.
Operation
SETUP-Taste
Autostart
Abort at Q = 0
Pump pre-run time
Date / time
Bus address
Operating hours
Battery voltage
BS pressure supply
Additional test
Autostart:
Abort at Q = 0
HYDAC Filtertechnik GmbH
yes The FCU starts automatically after switching on with
measuring in the pre-set measurement mode (Autostart
function)
no Start of measurement must be triggered manually.
yes If the flow rate through the sensor falls to the value "0",
then measurement is aborted and the FCU switched off.
no
If the flow rate through the sensor falls to the value "0",
then measurement is aborted, but the FCU still remains
switched on and continues measuring when sufficient flow
is available.
E
Doc.: 3109776 Ed.: 01/13.02.2002
Page 111