Operating The Model; Inserting And Connecting The Flight Battery; Setting The Centre Of Gravity - Reely SKY F-16 ARF Notice D'emploi



9. Operating the model

a) Inserting and connecting the flight battery
The flight battery is inserted in the battery recess in the front of the cockpit and
secured using Velcro tape (1).
The exact position of the battery is determined by the centre of gravity.
The battery connection cable (1) must be connected to the cables of the speed
controller (2).
b) Setting the centre of gravity
The flight battery must be installed in the battery compartment so that the centre
of gravity is approx. 75-90 mm behind the leading edge of the wing.
Mark the position of the centre of gravity on the wing bottom on the left and the
right of the fuselage using a pen.
From the bottom, hold the assembled and ready-to-fly model at the measured
positions with your index fingers. If the centre of gravity is set correctly, the
model should be slightly leaning forward.
For the first flights, the centre of gravity should be at 75 mm. The optimal centre
of gravity can then be determined gradually and readjusted.
Figure 40
Figure 41
Figure 42
47