Carton Contents - Ryobi RDP102L Manuel D'utilisation

EN
FR DE ES IT NL
rEcoMMEnDED accEssoriEs
warninG
Use only accessories recommend for this drill press.
Follow instructions that accompany accessories. Use of
improper accessories may cause hazards.
■ Drill bits
■ Hold-down clamps
■ Drill press vices
warninG
Use only accessories designed for this drill press to
avoid injury from thrown broken parts or workpieces.
Do not use any accessory unless you have completely
read the instruction or operator's manual for that
accessory.

carton contEnts

unpacKinG anD cHEcKinG contEnts
warninG
If any part is missing or damaged, do not plug the drill
press in until the missing or damaged part is replaced,
and assembly is complete.
Carefully unpack the drill press and all its parts, and
compare against the list below.
To protect the drill press from moisture, a protective
coating has been applied to the machined surfaces.
Remove this coating with a soft cloth moistened with
kerosene or WD-40.
warninG
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the drill press.
Apply a coat of paste wax to the table, column and
machined surfaces of base to prevent rust. Wipe all
parts thoroughly with a clean dry cloth.
item Description
1 Head assembly
2 Table
PT DA SV FI NO RU
English
Quantity
1
1
PL CS HU RO LV LT
3 Base
4 Rack
5 Column assembly
6 Rack ring
7 Feed handles
8 Worm gear
9 Table lock handle
10 Table crank handle
11 Hex bolts
12 Chuck
13 Chuck key
14 4 mm hex key
15 3 mm hex key
assEMBly anD aDjustMEnts
For your own safety, never connect plug to power
source outlet until all assembly steps are complete and
you have read and understood the safety and operating
instructions.
The drill press is a heavy power tool and should be lifted
with the help of two people or more to safely assemble
it.
assEMBlinG coluMn to BasE
See Figure 5.
1. Place the base on a flat, stable surface.
2. Align screw holes in the column assembly with screw
holes in the base.
3. Place a hex bolt in each hole.
4. Tighten each hex bolt using an adjustable wrench.
installinG taBlE to coluMn assEMBly
See Figures 6-10.
1. Insert the table bracket lock handle into the threaded
hole at the rear of the table bracket.
notE: Install the handle from left to right, so it enters
the non-threaded side of the table bracket first.
2. Feed the worm gear through the table crank hole in the
table bracket. Make sure the worm gear meshes with
5
ET HR SL SK BG UK
1
1
1
1
3
1
1
1
3
1
1
1
1
warninG
warninG
TR EL