Beurer BC 57 Mode D'emploi page 34

Step 1: BC 57
Activate Bluetooth ® on your device (see
chapter 4 "Preparing the measurement,
Bluetooth ® ").
Step 2: " beurer Health Manager" app
In the " beurer Health Manager" app, add
the BC 57 under "Settings/My devices".
Step 3: BC 57
take a measurement.
Step 4: BC 57:
data transfer immediately
following measurements.
• If Bluetooth ® data
transfer has been ac-
tivated, data is trans-
ferred after having
confirmed the user
memory and pressing
the START/STOP but-
ton .
The " beurer Health Manager" app must be active to
allow data transfer.
If your smartphone has a protective cover, remove this
to ensure that there is no interference during the transfer.
Begin the data transfer in the " beurer Health Manager"
app.
We would explicitly draw attention to the fact that the
software to hand is not a medical product in accordance
with EU Directive 93/42/EEC.
The values displayed are purely for visualisation purposes
and must not be used as a basis for therapeutic treat-
ments. The software is not part of a diagnostic-medical
system.
34
Step 4: BC 57:
Data transfer at a later
point:
• Go to memory mode
(chapter 7). Select the
desired user memory.
The Bluetooth ® transfer
starts automatically.