Electric Bicycle System; Turning On The Electric Bicycle System; Turning Off The Electric Bicycle System - Panasonic FLYER Mode D'emploi

Electric bicycle system

To enable the assist function or display the various indications, press the power button on the console to turn on the electric bicycle system.

Turning on the electric bicycle system

1) Press the power button on the console.
● The battery level indication lamps, etc. light.
When you start pedalling, the assist function starts to work.
Attention
● Before pressing the power button, do not place your feet on the pedals of the electric bicycle. Otherwise, this will result in a torque sensor
error or less of an assisted sensation.
Press the power button again without placing your feet on the pedals.
● While pressing the power button, do not press any other buttons, otherwise an error may be displayed.
In this case press the power button again without your feet on the pedals.
● When the battery is being charged while still mounted on the electric bicycle, the motor unit will not start. Accordingly, the electric bicycle
system will not turn on.
● Do not turn on/off the power button while travelling. If the assist function is not required, press the assist mode select buttons ( / ) to select
[NO ASSIST].
Note
● The assist function of the electric bicycle will not work in the following cases:
– When you stop pedalling
– When a speed of 25 km/h is reached (The assist function starts to work by starting to pedal again at 25 km/h or less.)
– When there is no remaining battery power

Turning off the electric bicycle system

1) Press the power button on the console when the electric bicycle system is turned on.
Note
● Even if the power button is not pressed to turn off the electric bicycle system, the power automatically turns off to save energy if the electric
bicycle is not used for about ten minutes (for example, when the electric bicycle is parked).
Chapter 3 Methods of Use — Electric bicycle system
Power button
154