Storage And Transport; Maintenance And Service; Maintenance And Cleaning; Accessories - Bosch PTS 10 Notice Originale

OBJ_BUCH-783-001.book Page 50 Thursday, July 3, 2008 12:02 PM
50 | English

Storage and Transport

(see figure N)
Storing the Power Tool
For storage purposes, the hold-down stick,
stops/fences and spare saw blades can be se-
curely fastened to the power tool.
– Lock the yellow safety flap 30 and the locking
lever 24 of the sliding table 1.
– Bring the machine into the transport posi-
tion. (see "Transport Position", page 46)
– Loosen the auxiliary parallel fence 18 from
the parallel fence 8 or from the angle stop 16.
– Position the stops/fences (8, 16, 18) and fas-
ten the hold-down stick 22.
– Wind the mains cable around the cable hold-
er 31.
– A spare saw blade can be fastened to the ma-
chine housing for storage with help of the
fastening screw 19.
Carrying the Power Tool
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, only use
the transport fixtures. Never carry the pow-
er tool by the protective devices, the table
extension 2 or the table width enlargement
9.
– For lifting or transporting, hold the power
tool by the recessed grips 67 on the side of
the saw table.
1 609 929 R65 | (7/3/08)

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.

Accessories

Base unit . . . . . . . . . . . . . . . . . . 2 607 001 967
Saw blades for wood and plate materials, pan-
els and strips/mouldings
Saw blade 254 x 30 mm,
40 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 443
Saw blade 254 x 30 mm,
60 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 444
Bosch Power Tools