Bosch PTS 10 Notice Originale page 43

OBJ_BUCH-783-001.book Page 43 Thursday, July 3, 2008 12:02 PM
Assembly from Below
– Place down the power tool upside down on
its saw table 11.
Mounting the Vacuum Hose
(see figure a)
– Connect the sawdust ejector on the saw
blade casing and the sawdust ejector 32 on
the machine housing with the vacuum hose
34.
Mounting the Bottom Plate
(see figure b)
– Insert the bottom plate 35 into the intended
recesses so that the mounting holes corre-
spond with the holes in the bottom plate.
– Tighten the bottom plate with the Phillips
screws provided.
Assembly from Above
– Turn the power tool around so that it is in the
correct working position.
Mounting the Riving Knife
(see figures c1 – c3)
For assembly, use the fastening kit for "riving
knife" 36. (2 hexagon bolts)
– Using the ring spanner 17, lift up the insert
plate 3 at the front and remove it from the
notches 37.
– Turn handwheel 12 in anticlockwise direc-
tion to the stop so that the saw blade 38 is in
the highest possible position above the saw
table.
– Loosen locking knob 29 to tilt the saw blade
38.
– Position the riving knife 4 in front of the fix-
ture 39 in such a manner that the holes of
both parts are in alignment.
– Screw the riving knife with the hexagon bolts
to the fixture using the ring spanner 17
(10 mm).
– Readjust the saw blade back to 90° again
and tighten locking knob 29. (also see "Ad-
justing Vertical Bevel Angles (Saw Blade)",
page 46)
Bosch Power Tools
Note: The riving knife must be in alignment with
the saw blade to avoid jamming of the work-
piece.
– Finally, reassemble the insert plate 3.
For this, hook the insert plate into the notch-
es 37 and then press the insert plate down-
ward until it engages in the saw table.
Mounting the Blade Guard
(see figure d)
For assembly, use the fastening kit for "blade
guard" 40. (screw, nut, washer)
– Insert screw 40 through the holes of the
blade guard and riving knife.
The square head of the screw must engage in
the corresponding recess of the blade guard.
– Mount the washer and the nut.
– Tighten the nut sufficiently with the ring
spanner 17 (10 mm) so that the blade guard
remains secured in any set position.
Mounting the Table Extension
(see figures e1 – e2)
For assembly, use the fastening kit for "table ex-
tension" 41. (2 guide rods, 2 securing screws,
2 clips, 2 short fastening knobs)
– Insert both guide rods (rod end with thread-
ed hole ahead) to the stop into the appropri-
ate holes on the table extension 2.
– Screw the rubber buffer 42 onto the table ex-
tension.
– Fasten the guide rods to the extension bar by
inserting the clips into the threaded holes.
– Afterwards, insert the table extension via
both guide rods into the intended fixtures
under the saw table.
– Screw the securing screws against pulling
out, into the threads intended for this pur-
pose.
– Screw the fastening knobs 23 into the
threads intended for this purpose under the
saw table.
English | 43
1 609 929 R65 | (7/3/08)