Technical Data; Noise/Vibration Information; Declaration Of Conformity; Certification - Bosch PTS 10 Notice Originale

OBJ_BUCH-783-001.book Page 41 Thursday, July 3, 2008 12:02 PM
57 Scale for bevel angle (vertical)
58 Lens
59 Scale for clearance of the saw blade to the
parallel fence 10
60 ON pushbutton
61 Adjusting screw for setting the standard 90°
bevel angle
62 Adjusting screw for setting the standard 45°
bevel angle
63 Screw for angle indicator (vertical)
64 Nut for adjustment of the parallel-fence ten-
sioning force 8
65 Adjusting screws for sliding-table play
66 Adjusting screws for insert plate
67 Recessed grips
68 Fastening kit for "base unit"*
69 Base unit*
*The accessories illustrated or described are not in-
cluded as standard delivery.

Technical Data

Table saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Reduced starting
current
Weight according to
EPTA-Procedure
01/2003
Protection class
Maximum workpiece dimensions, see page 48.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Bosch Power Tools

Noise/Vibration Information

Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 97 dB(A);
Sound power level 110 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
PTS 10
2006/42/EC (from 29 Dec 2009).
3 603 L03 2..
Technical file at:
W 1400
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
V 230
Dr. Egbert Schneider
Hz 50
Senior Vice President
rpm 5000
Engineering
kg 23.5
04.07.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
/ II
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Saw blade mounting
hole
Dr. Eckerhard Strötgen
Head of Product

Certification

1 609 929 R65 | (7/3/08)
English | 41
mm 254
mm 1.8
mm 30