Product Features; Technical Data; Battery Charging - Bosch GSA 36 V-LI Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-606-002.book Page 9 Monday, April 6, 2009 9:51 AM

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Saw blade*
2 Adjustable footplate
3 Saw blade holder
4 Locking sleeve for saw blade
5 Stroke rod
6 Utility hook
7 Stroke speed selector switch
8 On/Off switch
9 Battery unlocking button
10 Battery*
11 Temperature control indicator
12 Battery charge-control indicator
13 Button for charge-control indicator
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.

Technical Data

Sabre saw
Article number
Rated voltage
Stroke rate at no load n
0
– 1st gear min
– 2nd gear min
Tool holder
Stroke rate control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according
to EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Bosch Power Tools
Assembly

Battery Charging

Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
WARNING
chine has been automatically switched off. The
battery can be damaged.
Removing the Battery
The battery 10 is equipped with two locking lev-
GSA 36 V-LI
els that should prevent the battery from falling
Professional
out when pushing the battery unlocking button
3 601 F45 R.. 9 unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
V= 36
means of a spring.
-1
0 – 2400
-1
0 – 3000
SDS
mm 28
mm 250
mm 20 To remove the battery 10:
mm 130
– Push the battery against the base of the pow-
er tool (1.) and at the same time press the
battery unlocking button 9 (2.).
– Pull the battery out of the power tool until a
kg 4.2
red stripe becomes visible (3.).
– Press the battery unlocking button 9 again
and pull out the battery completely.
English | 9
Do not continue to press the
On/Off switch after the ma-
1 609 929 P01 | (6.4.09)