Accessing The Menu - Astoria Core600 Manuel D'utilisation Et D'entretien

7.2.2 Programming the automatic hot water
The machine is programmed by default. Should the
hot water doses need to be modified, proceed as follows:
• Place the jug under the hot water nozzle;
• Press the button for at least 5
seconds until all of the dose button
LEDs are lit;
• Press the hot water dispensing
button ;
• To confirm the dose press the
button again;
• When the programming is com-
plete, press the
all of the LEDs on the push button
panel go off.
66 288
of
button until

7.2.3 Accessing the menu

To access the machine's programming modes and
where the data can be viewed, touch the display twice.
Select the various buttons to access the sections
indicated in the following paragraphs.
The system will automatically exit the programming mode 20
seconds after the last action was carried out.
Always use the right-hand side push button panel for the
programming modes.
45°C
Machine
warnings
Steam wand/cup warmer
Boiler pressure
Language
settings
Work
count
Energy
saving mode
temperature
Standby and
programming
Machine working
hours
USER manual