Introduction; Guidelines For Reading The Manual; Storing The Manual; Method For Updating The Instruction Manual - Astoria AL Série Manuel D'utilisation Et D'entretien

1.

INTRODUCTION

Please read this manual in its entirety before using
the device, in order to optimize machine performance
and operate it safely.
The espresso coffee maker that you have purchased
has been designed and manufactured with innovative
methods and technologies which ensure long lasting
quality and reliability.
This Manual will guide you in discovering the advan-
tages of purchasing our product. You will find informa-
tion on how to get the best of your appliance, how to
always keep it efficient and what to do if you should have
any problems.
Keep this Manual in a safe place. If you lose it, you can
ask the Manufacturer for another copy.
Before using the machine, read the instructions contained in this
publication and follow the guidelines carefully. Keep this manual
and all publications attached in an accessible and secure place.
This document assumes that in the locations where the machine
is installed, the relevant safety standards and work hygiene are
observed.
The instructions, drawings and documentation con-
tained in this manual are technical and confidential,
the sole property of the Manufacturer, and may not be
reproduced in any way, either in full, or in part.
The Manufacturer reserves the right to make any
improvements and/or modifications to the product. We
guarantee that this Manual reflects the technical state
of the appliance at the time it is marketed.
We take this opportunity to invite customers to make
any proposals for improving the product or the Manual.

Guidelines for reading the Manual

1.1
The Manual is divided into separate chapters. The sequence of chapters
responds to the temporal logic of the life of the machine.
Terms, abbreviations and pictograms are used to facilitate the immediate
understanding of the text.
This Manual is constituted by a cover, an index and a series of chapters.
Each chapter is numbered in sequence. The page number is in the footer.
The first page shows the machine identification data, the last page shows
the date and revision of the Instructions Manual.
ABBREVIATIONS
Sect. = Section
Chap. = Chapter
Par. = Paragraph
P. = Page
Fig. = Figure
Tab. = Table
28 160
of
MEASUREMENT UNIT
The measurement units are those provided by the International System
(SI).
PICTOGRAMS
Descriptions preceded by these symbols contain information/very im-
portant requirements, particularly as regards safety. Failure to comply may
result in:
hazards to the operator safety;
injury also serious of the machine users (in some cases even death);
loss of the guarantee;
manufacturer's liability waiver.
DANGER symbol used in case of danger of permanent serious injury
that requires hospitalization, or causes death in extreme cases.
CAUTION symbol used in case of risk of minor injury that requires
medical attention.
WARNING symbol used in case of danger of minor injury that can
be treated with first aid or the like.
NOTE symbol used to provide important information related to
the topic.

Storing the Manual

1.2
The Instruction Manual must be stored carefully and must accompany
the machine in all the ownership transfers.
Storage should be favoured by handling it with care, with clean hands
and not depositing it on dirty surfaces. Do not remove, torn or arbitrarily
modify any of its parts.
The manual must be stored in an environment protected from moisture
and heat, in close vicinity of the machine it refers to.
On request, the manufacturer, can provide additional copies of the Instruc-
tions Manual of the machine.
Method for updating the Instruction
1.3
Manual
The Manufacturer reserves the right to modify and make improvements
to the machine without notifying it and without updating the Manual already
delivered to the user.
Moreover, in case of substantial changes to the already installed machine
involving the modification of one or more chapters of the Instruction Manual,
the manufacturer will send the users the chapters affected by the changes or
the revision of the entire manual.
It is the users' responsibility, to replace the old document with the new
revision.
The manufacturer is responsible for the Italian descriptions; the transla-
tions cannot be fully verified; therefore, in case of inconsistency, users must
pay attention to the Italian version and possibly contact the Manufacturer,
who will make the appropriate changes.
USER manual