Use; Before Machine Start-Up - Nilfisk Alto SCRUBTEC 545E Manuel D'utilisation

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal
1. Disconnect the power supply cable (3) from the electrical mains.
2. Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).
3. Lower the deck on the brush/pad-holder by pressing the pedal (8).
4. Connect the power supply cable (3) to the electrical mains.
5. Press the switch (51) to turn on the machine and the accessories.
6. Press one of the switches (55) to engage the brush or the pad-holder.
WARNING!
Do not press the switches (55) too much, otherwise the machine will start.
7. To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from the
hub, by turning it in the opposite direction to the normal rotation direction.
Types of brushes available
450 mm-models
08837020 - Prolene
08837023 - Midlite Grit 180
08837024 - Midgrit 240
08837021 - Prolite
08837022 - Union Mix
10
USER MANUAL
530 mm-models
08837025 - Prolene
08837028 - Midlite Grit 180
08837029 - Midgrit 240
08837026 - Prolite
08837027 - Union Mix
SCRUBTEC 545E – 553E
Figure 1
S311334
9097056000(1)2007-02 A