Fuse Check/Replacement - Nilfisk Alto SCRUBTEC 545E Manuel D'utilisation

ENGLISH

FUSE CHECK/REPLACEMENT

1. Disconnect the power supply cable (3) from the electrical mains but do not place it on the holder (4).
2. Move aside the recovery water drain hose (12).
3. Remove the power supply cable (3) from the holder (4).
4. Remove the screws (A, Fig. 6) and carefully move the panel (B).
5. Check/replace the following fuse:
(C) - F1, electronic board: (1 A)
6. Perform steps 2 to 4 in the reverse order.
B
A
18
USER MANUAL
A
SCRUBTEC 545E – 553E
C
A
A
Figure 6
P100114
9097056000(1)2007-02 A