Charging The Battery - Dogtra 2600T&B Guide D'utilisation

11. CHARGING THE BATTERY

The 2600T&B Series uses lithium polymer batteries.
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable
substances.
3. Fully charge the batteries if the unit is to be stored
without use for a period of 3 months or more.
Recharge the Unit If:
• The LED indicator light on the receiver/collar is
emitting a red color.
• If the 3 bar indicator on the transmitter LCD shows just
1 bar.
• The indicator light on the transmitter or receiver will
not come on.
• The indicator light on the transmitter or receiver comes
on momentarily, but will not stay on when the Constant
button is pushed.
64
Battery Charging Procedure
Note: The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use.
1. Attach the charging cables to both the transmitter
and receiver(s), as shown on page 64.
2. Plug the charger into a 230 volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries. All indicator lights should
glow red when properly plugged in and the unit will
automatically shut off during the charging process.
You will need to turn the unit on again before use
once the unit is fully charged and unplugged from the
battery cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will turn green once the unit is
fully charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver.
Note: Only use Dogtra approved batteries, chargers,
and accessories for your Dogtra e-collars. When a
charger is not in use, disconnect it from the power
source.
65