Dogtra 2600T&B Guide D'utilisation page 37

4. Watch the test light as you push the Nick button on
the transmitter. It should light up for just a moment.
The higher the intensity, the brighter the test light will
be.
5. Watch the test light as you push the Constant button
on the transmitter. It should light up as long as the
button is pressed. However, as a safety feature, the
receiver/collar will automatically stop the stimulation
if the Constant button is pressed for 12 seconds or
longer.
6. Turn the Rheostat Dial on the transmitter clockwise
and then counterclockwise. The test light should glow
brighter with higher levels of stimulation and dimmer
with lower levels. When you change the intensity dial,
the number on the LCD screen will change as well.
Note: The test light may not be visible if the intensity
level is set below level ten.
7. To make sure that your beeper is working properly,
press the Locate button once with the horn portion
facing away from you (or place your hand over
the horn). The sound may be extremely loud and
may cause discomfort to your ears. If you do hear
an audible beeper sound, your Locate button is in
working order.
70
8. Press the Mode button once; you should hear 2 rapid
beeps. This will put you into the Run/Point mode.
Keep the receiver/collar steady to mimic your dog at
a standstill point. Wait for a moment until you hear a
double beep every 2 seconds. You may proceed to the
next step if the double beep occurs.
9. Press the Mode button a second time; you should
hear 1 rapid beep. This will put you into the Point-Only
mode. Once again, keep your receiver/collar steady
and wait for a moment until the collar emits a double
beep every 2 seconds. If it is audible, move onto the
next step.
10. Press the Mode button a third time; you should hear 3
rapid beeps. This mode will turn off your beeper and
remain silent.
Note 1: The tone that the beeper will emit will vary
depending on which collar you selected. The orange
collar emits a low tone, the green collar emits a high
tone. If you wish to change the tone setting of a collar,
please contact us: info@dogtra-europe.com or by phone:
+33 (0) 130 62 65 65.
Note 2: When using the Run/Point mode or the Point-
Only mode, the beeper volume level reverts back to the
volume level that was last used.
71