Beeper Volume Adjustment; Collar Fitting - Dogtra 2600T&B Guide D'utilisation

4. BEEPER VOLUME ADJUSTMENT

The beeper volume level for the Run/Point mode and
Point-Only mode can be increased or decreased by
holding the Locate button down and briefly pushing the
Pager button. There are two beeper tones: High (H1 =
lowest volume, H2 = medium volume, and H3 = highest
volume) for the green collar and Low (L1 = lowest volume,
L2 = medium volume, and L3 = highest volume) for the
orange collar. If you want to change the tone of your
collar(s) from High to Low or from Low to High, email us
at info@dogtra-europe.com or call customer service at
+33 (0) 130 62 65 65.
Toggle Switch
High LCD Displays
Press Pager 1st Time
(While holding down
the Locate button)
Press Pager 2nd Time
(While holding down
the Locate button)
Press Pager 3rd Time
(While holding down
the Locate button)
Note: The Locate beeper volume is not
adjustable; it is always on the highest level, L3 on low
tone, or H3 on high tone.
58
Toggle Switch
Low LCD Displays
H1 L1
H2 L2
H3 L3

5. COLLAR FITTING

Proper Fit
The collar should be fitted so that the surgical stainless
steel contact points press firmly against the dog's skin.
You should be able to fit a finger in between the contact
point and your dog's skin. The best location is on either
side of the dog's windpipe.
Improper Fit
A loose fit can allow the collar to move around on the
dog's neck. When this happens, the contact points may
rub against the skin and cause irritation. If the collar is
too loose, the contact will not be consistent and cause
the corrections to be inconsistent. Dogtra uses surgical
stainless steel contact points and anti-microbial plastic
to protect the dog's skin.
59