Service Indicator With Reset Button; Changing The Batteries On The Led Handle; When To Change The Thread Catcher Of The Standard Floor Brush - Miele SGDE0 Instructions D'utilisation

Important
Make sure that only one exhaust
filter is inserted in the frame.
1. If you replace exhaust filter a with
exhaust filter b or c, you must be sure
to remove the filter frame before
inserting the new filter type. The
exhaust filter change indicator must
also be activated (see fig. 12).
2. If you replace exhaust filter b or c
with exhaust filter a, you must be sure
to place the new filter in the filter frame
* (see fig. 37).
* Filter frame - see section on "Optional
accessories"

Service indicator with reset button

(see fig. 40)
(depending on model)
The indicator light will come on after
approx. 50 hours of operation, which is
equivalent to one year of average use.
Check if the motor protection filter and
the exhaust filters need to be replaced
as well. You will need to reset the
indicator after replacing any of these
components.
To do this, the vacuum cleaner must be
turned on.
^ Press the reset button.
The service indicator will go out and be
reset to its original position.
The reset feature only works properly
if the indicator light has already come
on, but not if the reset button is pres-
sed in between filter changes.
Changing the batteries on the LED
handle (see fig. 15 + 16)
(depending on model)
You will need three AAA (1.5V) batteries.
a Loosen the screws on the cover.
b Press down on both sides of the
cover to remove.
c Take out the battery holder and
change the 3 batteries, making sure
they are inserted correctly.
d Replace the battery holder in the
direction of the arrows on the holder
and battery compartment, so that
both line up.
e Replace the cover and tighten the
screws.
Cleaning the floor roller of the floor
brush AllTeQ (see fig. 41)
(depending on model)
a Release the roller pin using a coin.
b Push and take out the roller axle.
c Take out the roller.
^ Remove all threads, hair etc. and
reinstall the roller and lock the roller
pin.
When to change the thread catcher
of the standard floor brush
(depending on model)
The thread catcher on the standard
floor brush can be replaced when the
pile is worn out.
en
19