How Do I Change The Active Airclean 50 Or The Hepa Airclean 50 Exhaust Filter; Exchanging Exhaust Filters; Service Indicator With Reset Button - Miele SGNE0 Instructions D'utilisation

en
But if you want to install an Active Air-
Clean 50 filter or HEPA AirClean 50
filter, you must heed the section
"Maintenance and care - Exchanging
exhaust filters".
^ Close the filter frame.
^ Close the dust compartment lid until
it clicks into place.
How do I change the Active AirClean
50 or the HEPA AirClean 50 exhaust
filter? (see fig. 32 + 33)
Make sure that only one exhaust
filter is inserted in the frame.
^ Open the dust compartment lid.
^ Lift the Active AirClean 50 or HEPA
AirClean 50 exhaust filter and remove
it.
^ Install the new Active AirClean 50 or
HEPA AirClean 50 exhaust filter and
press it downwards.
^ Press the exhaust filter change
indicator ~ (see fig. 11).
^ After about 10-15 seconds, a small
red marker will appear in the left-hand
side of the display (see fig. 12).
If you want to install an AirClean
exhaust filter, you must adhere to
the section "Maintenance and care -

Exchanging exhaust filters".

^ Close the dust compartment lid until
it clicks into place.
20
Exchanging exhaust filters
Make sure that only one exhaust
filter is inserted in the frame.
Depending on the model, your vacuum
cleaner will use one of the following
standard exhaust filters (see fig. 8):
a AirClean Filter
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Important
1. If you replace exhaust filter a with
exhaust filter b or c, you must be sure
to remove the filter frame before
inserting the new filter type. The
exhaust filter change indicator must
also be activated (see fig. 11).
2. If you replace exhaust filter b or c
with exhaust filter a, you must be sure
to place the new filter in the filter frame
* (see fig. 31).
* Filter frame - see section on "Optional
accessories"

Service indicator with reset button

(see fig. 34)
The indicator light will come on after
approx. 50 hours of operation, which is
equivalent to one year of average use.
Check if the motor protection filter and
the exhaust filters need to be replaced
as well. You will need to reset the
indicator after replacing any of these
components.
To do this, the vacuum cleaner must be
turned on.
^ Press the reset button.