Replacing The Active Airclean 50, Airclean Plus 50 And Hepa Airclean 50 Exhaust Filters; Replacing One Type Of Exhaust Filter With Another; When Changing The Filter Please Note; When To Change The Thread Lifters - Miele Complete C2 Série Mode D'emploi

If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA
AirClean 50 filter, see "Replacing one
type of exhaust filter with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 50,
AirClean Plus 50 and HEPA AirClean
50 exhaust filters (dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
 Press the exhaust filter timestrip in-
dicator (dia. 15).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 16).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 12)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.

When changing the filter please note

1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
You must also activate the exhaust
filter timestrip indicator (dia. 15).
2. If you wish to replace exhaust filter b,
c or d with filter a, it is essential that
you also fit the filter grille * (dia. 35).
* Filter grille - see "Optional ac-
cessories".

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 38)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 39)
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
en
43