When To Change The Thread Catcher Of The Floor Brush Allteq; (Depending On Model); Replacing The Thread Catchers; Cleaning And Care - Miele SGNE0 Instructions D'utilisation

The service indicator will go out and be
reset to its original position.
The reset feature only works properly
if the indicator light has already come
on, but not if the reset button is pres-
sed in between filter changes.
Cleaning the floor roller of the floor
brush AllTeQ, see fig. 35

(depending on model)

a Release the roller pin using a coin.
b Push and take out the roller axle.
c Take out the roller.
^ Remove all threads, hair etc. and
reinstall the roller and lock the roller
pin.
When to change the thread catcher
of the floor brush AllTeQ (depending
on model)
The thread catcher on the floor brush
AllTeQ can be replaced when the pile
is worn out.
Replacing the thread catchers (see
fig. 36)
^ Use a screwdriver or similar object to
remove the thread catchers from the
slots.
^ Insert the new thread catchers.
New thread catcher pads can be
purchased from any authorized Miele
vacuum dealer or Miele.

Cleaning and care

,
Turn off the vacuum and unplug
it from the outlet before performing
any maintenance work.
Vacuum cleaner and accessories
The vacuum cleaner and other plastic
accessories can be cleaned with a
damp cloth or a cleaner suitable for
plastics.
,
Do not use abrasive, oil-based,
glass or all purpose cleaners!
Dust compartment
The dust compartment can, if
necessary, be cleaned using a dry
cloth, dusting brush or a second
vacuum to remove any dust.
Monitor the filter bag change indicator
and inspect all filters regularly. Clean or
replace them when necessary
according to these Operating
Instructions.
,
Do not submerge the vacuum in
water. If moisture gets into the
appliance there is the risk of an
electric shock.
en
21