Exchanging Exhaust Filters; Changing The Batteries On The Led Handle; When To Change The Thread Catcher Of The Standard Floor Brush; How To Change The Thread Catcher - Miele S 8000 Instructions D'utilisation

en

Exchanging exhaust filters

Depending on the model, your vacuum
cleaner will use one of the following
standard exhaust filters (see fig. 31):
a Air Clean
b Active Air Clean SF-AAC 50 (black)
c Active HEPA SF-AH 50 (blue)
Important
1. If you replace exhaust filter a with
exhaust filter b or c, you must be sure
to remove the filter frame before
inserting the new filter type.
2. If you replace exhaust filter b or c
with exhaust filter a, you must be sure
to place the new filter in the filter frame
* (see fig. 34).
* Filter frame - see section on "Optional
accessories"
Make sure that only one exhaust
filter is inserted in the frame.
Certain models are equipped with a
filter change indicator (see fig. 32)
to show you when to change the
Active Air Clean or Active HEPA
filter. If you use an Air Clean exhaust
filter instead, lighting of the filter
change indicator and reset button
can be disregarded as you simply
replace the exhaust filter every time
a new box of Miele filter bags is
opened. The indicator lights turn off
when the reset button is pressed.
18
Changing the batteries on the LED
handle (see fig. 9 + 10)
You will need three AAA (1.5V)
batteries.
a Loosen the screws on the cover.
b Press down on both sides of the
cover to remove.
c Take out the battery holder and
change the 3 batteries, making sure
they are inserted correctly.
d Replace the battery holder in the
direction of the arrows on the holder
and battery compartment, so that both
line up.
e Replace the cover and tighten the
screws.
When to change the thread catcher
of the standard floor brush
The thread catcher on the standard
floor brush can be replaced when the
pile is worn out.

How to change the thread catcher

AllTeQ floor tool (see fig. 37)
^ With a screwdriver, for example, lift
the thread catcher out of the slots.
Two indents are provided for this
purpose.
^ Insert the new thread catcher.
AirTeQ floor tool (see fig. 38)
^ With a screwdriver, for example, lift
the thread catcher out of the slots.
^ Insert the new thread catcher.